X6100作为一个sdr机器，频谱没法引出来给电脑上看或者远程观看也太可惜了。目前有第三方固件可以从dev口引出x6100的频谱吗？使用机内wifi和host口会给频谱带来巨大干扰，所以不用这两个最好。我之前用双通道声卡配合iq输出口测试过，sdrpp内显示频谱但底噪巨大，即使在机器显示S7以上也几乎也是不可用的状态，原因未知，如果谁有双声道声卡或者相关折腾经验也欢迎分享）感谢各位（）

没有x6100的机器，只是想起来之前看到wfview支持了x6100新固件的连接，不太清楚是仅支持电台控制还是和icom设备一样支持频谱图显示😂有一个帖子使用wfview连接了x6100，看起来好像是有频谱显示的，不过据说延迟巨大，你手里有机器的话可以试一试

用i/q接口引出，接到一个高采样率的立体声录音声卡来采样。建议使用192kHz以上的采样率，采样率=频谱最大宽度。但是需要知道你的i/q输出带宽有多少，g90的i/q可以覆盖192kHz。

How to generate a spectrum for the X6100?

BI1FJK

The X6100, as an SDR device, is a waste because it cannot output the spectrum to a computer for viewing or remote monitoring. Is there currently any third-party firmware that can output the X6100's spectrum via the debug port? Using the internal Wi-Fi and host port will cause significant interference with the spectrum, so it's best not to use these.
I previously tested with a dual-channel sound card and iq output port, and the spectrum displayed in SDRpp was very large, even when the machine showed S7 or higher, it was almost unusable. The reason is unknown. If anyone has experience with dual-channel sound cards or related troubleshooting, please share it. Thank you all.

BD1CAZ

I don't have an x6100, but I remember seeing that wfview supports connecting to the new firmware for the x6100. I'm not sure if it only supports radio control or also supports spectrum display like with the icom device. There was a post where someone used wfview to connect to an x6100, and it seemed like it had a spectrum display, but apparently there was a huge delay. If you have one, you could try it out.

BD7PPA

Using the I/Q interface, connect a high-sampling rate stereo audio card for sampling. It is recommended to use a sampling rate of 192 kHz or higher, where the sampling rate equals the maximum width of the spectrum. However, you need to know the bandwidth of your I/Q output; the g90's I/Q can cover 192 kHz.

闽ICP备2021006864号-7

闽公网安备35020602002794号互联网举报中心

用户协议隐私政策社区规范积分规则中继规则转载须知
更新日志联系我们常见问题友情链接运营报告赞助

浩奇科技（厦门）有限公司

是无线电，把我们联系在一起