请教一下，我泉盛黑金刚手台需要设置频率为438.438，但是我手动直接按，按不到这个频率，最后三位按了438就变成435，我把步进调成了6，再设置最后三位只能是437.5。请教一下我应该怎么弄能把后三位设置成438，谢谢

@"gfsn989"#p86603 步进频率盖小点

@"BH6SVA_AC3QU"#p86605 步进频率最小是5，然后6.5 10 12.5 15 30 50 100，步进没有1。不知道怎么弄了

@"gfsn989"#p86606 都不能整除，换全模式台吧。但是，这个不会是XY问题吧，什么情况会用这么零碎的频率？

How to tune the QuanSheng Black Diamond UV2 PLUS radio to 438.438 MHz?

gfsn989

Could you please advise me? I have a QuanSheng Black Diamond hand-held radio, and I need to set the frequency to 438.438. However, when I manually enter the digits, it only goes up to 435 if I press 438, and when I adjust the last three digits to 437.5, it doesn't work. How can I get the last three digits to display 438? Thank you.

BH6SVA_AC3QU

gfsn989 Reduce the step frequency.

gfsn989

BH6SVA_AC3QU The minimum step frequency is 5, followed by 6.5, 10, 12.5, 15, 30, 50, and 100. There is no step frequency of 1. I don't know how to do this.

BloodBlade

gfsn989 None of them divide evenly, so let's switch to a different mode.

However, this doesn't seem like an XY problem, does it? What situation would require such fragmented frequencies?

闽ICP备2021006864号-7

闽公网安备35020602002794号互联网举报中心

用户协议隐私政策社区规范积分规则中继规则转载须知
更新日志联系我们常见问题友情链接运营报告赞助

浩奇科技（厦门）有限公司

是无线电，把我们联系在一起