已将IC718连接至n1mm实现了软件和电台间的联动，但音频输入未解决，在JTDX上使用外接声卡的方案，在n1mm上好像做不到这样

我891，同样没有内置声卡，用玩FT8那条线输入输出音频到电脑3.5mm声卡口，配合N1MM没有问题，SSB也没有问题

要不别费劲了。。挂咸鱼吧。。这718克你🤣

ACC连接电脑音频，使用RTS/DTR控制ptt和cw自动拍发

@"Anonymous8"#p83599 设置DTR CW之后盒子蜂鸣器倒是在发CW，电台PTT触发了但是并没出功率

解决了，盒子切换到cw模式后背面cw接口启用，缺少一根音频线连接盒子和电台，现在正常实现拍发了

How can a radio station without an internal sound card use n1mm to achieve automatic CW?

BI3AFQ

I have connected the IC-718 to n1mm, achieving synchronization between the software and the radio, but the audio input issue remains unresolved. Using an external audio card in JTDX seems to be a viable solution, but it doesn't appear possible on n1mm.

BA7NNC-JOE

My callsign is 891, and I also don't have a built-in sound card. I use the audio input/output line for FT8 to connect to my computer's 3.5mm audio jack, and it works fine with N1MM and SSB as well.

Ethan

Or, just give up... hang it up... this 718 gram one.🤣

BI3AFQ

Anonymous8 After setting DTR CW, the box's speaker was emitting CW, but the radio's PTT didn't output any power.

BI3AFQ

The issue has been resolved. After switching the box to CW mode, the rear CW interface is enabled. A cable was missing to connect the box and the radio. Now it's working correctly and I have successfully transmitted a CQ call.

闽ICP备2021006864号-7

闽公网安备35020602002794号互联网举报中心

用户协议隐私政策社区规范积分规则中继规则转载须知
更新日志联系我们常见问题友情链接运营报告赞助

浩奇科技（厦门）有限公司

是无线电，把我们联系在一起