What type of support is suitable for a Yagi antenna?

BG5BJM

最近搞了个一部HexBeam天线，标称6.5公斤，实测7.2公斤。加了点延长杆和夹具后最后达到8公斤。

天线需要5米以上高度架设，最低3米勉强可用。

现在手里有一个4.8米灯架，最高承重6公斤。商家说降低高度可以增加承重。

升高后风绳拉紧、适当降低高度可不可以勉强使用
各位有没有什么好办法？推荐的架子？

需要能装到汽车后备箱里，也希望太长太重。比如现在的灯架收纳后大约1.2m，已经是极限了。

Liridice

The 7-meter light pole doesn't need to be extended to its full length, but it won't fit in the trunk. The only way to use it is for a 5-door car to extend it from the back to the front.

BG5BJM

Liridice Indeed, it's too long.

BH7HQT

There aren't many good solutions for large antennas. I'm currently considering a reverse-V configuration, and my current plan is to use a 7-meter carbon fiber support pole + an umbrella base + guy ropes as a reference.

BG5CPM

BH7HQT I also used the same scheme, and found that it was relatively lightweight and convenient in practice.

BA7NNC-JOE

Currently, most of my portable radio QSOs are conducted using a 4.8-meter tower, along with a 20-meter inverted V antenna and a 15-meter/10-meter dipole combination.

Currently, Spider-Man's power level isn't high enough to compete.

BG5BJM

BA7NNC-JOE Could you provide an image? I was planning to do something similar, but I haven't been able to try it because there are too many ropes. I have a DP puller and a 20-meter V-shaped puller, but the latter takes up too much space.

BG9CHE

The 6-meter pneumatic pole I use has no problems with its load capacity, but it's not very convenient to carry and set up.

BG5BJM

BG9CHE I want one too, but I can't seem to fit it in. 🤣

BG5VXJ

As long as the location is good, any antenna will work.

BG5BJM

I tested it today, and only installed the low-frequency part (10m and 12m). When raised to a height of 4 meters, I tightened the guy ropes and gave them a few pulls, which seemed relatively stable. It can be used with some difficulty.

The equipment box, antenna, and lamp stand are already full in the trunk, and I still need to lay it down diagonally.

BI1RKA

BG5BJM
Was the teacher's spider web purchased or made themselves?

BA7NNC-JOE

BG5BJM

Essentially, this involves using two inverted-V oscillators, each with a length of 20/15 meters, and connecting them to the root of the 10-meter wavelength segment of the inverted-V. This combination creates a three-segment wave.

BG6UA

GP remote control, convenient and fast.

BV7SQ

This is really useful!
Bought on Taobao for ¥188.

BH1LAF

Is it a V-shaped handle?

闽ICP备2021006864号-7

闽公网安备35020602002794号互联网举报中心

用户协议隐私政策社区规范积分规则中继规则转载须知
更新日志联系我们常见问题友情链接运营报告赞助

浩奇科技（厦门）有限公司

是无线电，把我们联系在一起