大佬们，有啥办法区分新版本吗？今天早上，在抖音看到了一个大佬，加完内存后，刷固件，发现不能开机。最后发现是芯片变了，不能刷第三方固件了。

买的时候直接问商家能不能刷机就好了

@"BG7MGW"#p79284 行，我问问

老款机器是不是要涨价了

我靠。，好家伙了，来真的啊，前几天问泉盛的那个小机器人微信，告诉我没有实锤啊😡

为不是为了让大家强制买太空大金刚TK11，或是芯片涨价了，换了便宜的芯片

@"BA4JJU"#p80007 主控芯片都换了，还蹭原来的型号，泉盛有点不讲究啊。

@"BI7ALG"#p80012 说是暂时用v2版本芯片，等v3调试好就能刷机了。用新型号估计得重新申报吧

Regarding the issue of being unable to flash the new QuanSheng UVK6 version.

BA4JJU

Hey everyone, are there any ways to distinguish between the new versions?
This morning, I saw a prominent figure on Douyin who upgraded the memory and then flashed the firmware, but was unable to boot up.
Finally, I discovered that the chip had been replaced, and it was no longer possible to flash a third-party firmware.

BG7MGW

When buying, directly ask the vendor if they can perform a factory reset.

BA4JJU

BG7MGW Okay, I'll ask.

BG5VXJ

Are older models going to become more expensive?

BI1WAH

Wow, this is incredible! It's actually happening. I asked about QuanSheng's little robot on WeChat a few days ago, and they said there was no proof.😡

BI3QAC

I'm not suggesting that everyone *must* buy the Space Big Gold TK11, or that chip prices have increased, so I've switched to a cheaper chip.

BA4JJU

看抖音的泉盛小机器人说，
k5现在用v2芯片，暂时不能刷机，等v3芯片调试好，使用v3生产后，就能刷机了。
说k6不受影响。

BI7ALG

BA4JJU The main control chips have all been replaced, and they even used the original models. QuanSheng seems a bit careless.

BA4JJU

BI7ALG
They said that we would be using the V2 version of the chip temporarily, and once the V3 has been debugged, we can flash it.
I think we should re-register it using the new model number.

BI4BSJ

Here's a post where I found the new firmware supported by QuanSheng UVK6 V3 after replacing the DP32G030 with a py32 chip:https://blog.mckero.com/posts/quansheng-k6-v3-firmware/

Firmware address:https://github.com/armel/uv-k1-k5v3-firmware-custom/wiki

闽ICP备2021006864号-7

闽公网安备35020602002794号互联网举报中心

用户协议隐私政策社区规范积分规则中继规则转载须知
更新日志联系我们常见问题友情链接运营报告赞助

浩奇科技（厦门）有限公司

是无线电，把我们联系在一起