用的机器是g106c，天线是MA 02端馈天线

1. 什么模式什么频率 2. 有没有收听到对方 3. 有没有尝试更容易成功的模式，例如FT8，或者约一个台友进行直频

1.注意传播规律，白天关注10米到15米，近期频率偏低还可以去20米，晚上关注20米到40米。 2.架设之后关注对应频率的FT8频点，看看收信效果如何，一般传播OK总能收到一些信号。 3.话音通信注意模式。 4.多读说明书，看看有没有什么设置在干扰你。 5.看看能不能和其他有经验的友台Eyeball一下，请他们指点。

先热机，熟悉机器功能，操作规范，不急着通联的，往后还有N多个1个月呢，莫捉急

我也木有，光干ft8了，环境不行

@"bd3rci"#p73903 其实我ft 8一个也没有通到

最近传播都不怎么样，不过20米还是可以的，FT8轻轻松松啊多尝试一下

最近 15m 波段 FT-8 挺热闹的。FT-8 应该随时都能有一堆日本台，非常容易。先试试收听，能不能成功解码出信息，如果没有，先找找机器、天线、设置的原因。

@"BG5VQE"#p73972 能听能解码，就是喊不到

I just got a new B phone, and I haven't been able to make any calls on it for a month. What should I do?

BG6HXC

The SSB power is too low; no one can hear it, even with weak signal reception, and there's no response. Try FT8 instead.

Ubuntu

BG6HXC I feel like SSB communication basically relies on receiving signals from the sky… and whoever has a stronger transmitter can usually be heard.

BI4PXL

1. Could the settings for the FT8 software be causing the ALC not to initialize or experiencing audio output issues?
2. Is the machine's power too small? Or are there obstructions along the antenna's extension path?
3. Is the background noise level too high here?
I also encountered similar problems when I first started using a 10W shortwave transmitter. However, I was able to successfully contact Finland on 14MHz using the MA01 transceiver and FT8. As long as the propagation conditions are favorable, you can achieve good results. The recent propagation seems to be average, so don't get discouraged!

Ubuntu

When using FT8, don't use SSB. Voice mode is often dominated by very powerful operators with signals of 100W or more. CW also works; just find a quiet location and start transmitting directly.

BG9PQO

I've been using it for about a month now, and I haven't had any problems with FT8. It seems to work with everything. SSB hasn't been successfully transmitted yet. I plan to install an antenna on the roof this weekend.

Hangying

Trying a more successful pattern for FT8

There's no spectrum available, and recent propagation has been poor.

BI1KPO

The most likely reason for the FT8 failure is that it was not properly configured. To put it dramatically, if you connect a wire to any point and transmit, you can potentially communicate with many receivers without damaging the equipment. It's impossible to only be able to contact one receiver after a month.

BG7NOD

BI7BNO Directly connecting with people is the most convenient option.

BD4TZY

For beginners, I recommend using an FT8 + single-band antenna or a pre-tuned antenna. First, use the antenna mentioned above... Then, learn more.

BG6RCW

If a beginner QRP 5W radio cannot make contact in SSB mode, it is understandable. However, if it cannot make contact in FT8 mode either, you should check your antenna and transceiver to ensure they are functioning correctly. With 5W FT8, it's easy to communicate internationally, and even within the country. In SSB mode, I recommend setting up an outdoor station. Avoid calling on frequencies used in busy markets. Instead, try contacting recently connected stations on adjacent or nearby frequencies. After announcing your callsign, add "QRP" to increase your chances of success. The best way to quickly enter the shortwave band is to find an experienced HAM and have them guide you through a successful contact.

« 上一页

闽ICP备2021006864号-7

闽公网安备35020602002794号互联网举报中心

用户协议隐私政策社区规范积分规则中继规则转载须知
更新日志联系我们常见问题友情链接运营报告赞助

浩奇科技（厦门）有限公司

是无线电，把我们联系在一起