有没有大佬可以教我一下

我也好奇这个问题，拿N76研究了一下，然后试出来一个基于HT的方案。把N76连到安卓手机的HT上面，为了避免干扰，换个无人使用的频率，比方说438.100MHz。在HT APP右上角点三个点，然后进入“设置”。分别进行以下设置： 1. `设置`-`ID信令`-最下面的`BSS/APRS路由`，`TTL`、`最大转发次数`两个设置成2 2. `设置`-`APRS设置`： * `登录`，输入自己的呼号密码，例如`BG4IJK-1` * 点亮`IGate网关`右边的开关，然后再点亮`无线电到互联网`的开关 * `分享位置`-`图标`，为了便于理解，找个铁塔的图标`/r` 调好之后，换另一个能发APRS的台子，频率同样设置成438.1MHz，呼号`BG4IJK-7`，图标小人，等设备成功定位（放在窗户边或户外）之后，用它往频率里发个信标，然后可以看到aprs地图上已经出现了两个`BG4IJK`，而且“小人”BG4IJK-7通过“铁塔”BG4IJK-1上报。

@"BG4IJK"#p51126 所以是ht软件把路径wide1-1 wide2-2拆成选项但是就没有办法加入类似ariss的路径了

@"BH3PTS"#p59003 可以啊[upl-image-preview uuid=d80f0f9b-7aae-41ef-a834-197c3eb76c80 url=https://storage.hamcq.cn/2025-03-30/1743353180-881566-screenshot-20250331-004509-ht.jpg alt={TEXT?}]

@"BA7NNC-JOE"#p59010 学到了，感谢

@"BG4IJK"#p51126 必须要另外一台能发aprs的机器才能完成aprs发送吗？我的n76按照帖子说的设置好了，我想通过网络发送，但是不在aprs.tv上显示。密码什么的都正确，这是怎么回事

@"BG4IJK"#p51126 我没看明白，不过我先插个眼，过两天慢慢研究下。

@"BI4MIG"#p94761 用AI把上面那段话翻译了一下： > 这段话其实是在教大家**如何把威诺 N76 当作一个“中转站”（网关），把周围收到的无线电定位信号（APRS）上传到互联网地图上**。为了让新手也能看懂，我把它翻译成一个**“保姆级教程”**版本： > ### **通俗易懂版：如何用 N76 搭建 APRS 网关** **核心原理：** 你要搭建一座桥。 * **桥的一头**是无线电波（你的 N76 对讲机）； * **桥的另一头**是互联网（你的安卓手机）； * **目的**：让 N76 听到周围友台的定位信号后，通过手机的网络传到 APRS 地图上。 > > #### **第一步：准备工作** 1. **硬件**：你需要一台威诺 N76 对讲机，和一台安装了“HT”APP（威诺官方APP）的安卓手机。 2. **连接**：把手机的蓝牙打开，连上 N76。 3. **选频**：把 N76 的频率调到一个**没人说话的空闲频率**（比如 438.100），防止干扰别人聊天，也防止别人干扰你传输数据。 > > #### **第二步：设置 APP（修路）** 打开手机上的“HT”APP，点右上角“三个点” -> “设置”，做两件事： 1. **设置转发规则（告诉机器怎么传）：** * 找到 `ID信令` -> 最下面的 `BSS/APRS路由`。 * 把 `TTL` 和 `最大转发次数` 这两项，都改成数字 **2**。（不用管为什么，照填就行）。 2. **设置网关身份（告诉地图你是谁）：** * 找到 `APRS设置`。 * **登录**：填你的呼号和 APRS 密码（比如 `BG4IJK-1`，后缀 `-1` 通常代表固定站点或网关）。 * **开开关**：先打开 `IGate网关`，再打开 `无线电到互联网`。（这步最关键，意思是：允许把收到的无线电波扔到网上）。 * **选图标**：建议选个“铁塔” `/r` 图标，这样别人在地图上一眼就知道你是个负责转发的基站。 > > #### **第三步：实战测试（验货）** 光设好了不行，得这就试试灵不灵： 1. **拿另一台对讲机**（这台机子要能发 APRS，比如手里的联畅UG-UV98或其他机子）。 2. 把这台测试机的频率也调成 **438.100**（必须和 N76 一样）。 3. 给测试机设个呼号（比如 `BG4IJK-7`，`-7` 代表手台），图标设个“小人”。 4. 拿着测试机走到窗户边或户外（确保能收到 GPS），**按一下发射键发送位置信标**。 > > #### **第四步：见证奇迹** 打开 APRS 地图网站（如 aprs.fi）： * 如果你看到了**两个图标**（一个是你的网关“铁塔”，一个是你的测试机“小人”）； * 并且点开“小人”的信息，发现路径里写着是**通过“铁塔”上传的**； **恭喜你，你的 N76 APRS 链路搭建成功了！** 在AI翻译上再补充一点，户外测试时，手机要和N76在一起

How to set up a Wi-No N76 APRS link?

BI1WOH

Could someone please help me?

BG4IJK

I was also curious about this question, and I researched it using N76, then tried to implement a solution based on HT.

Connect the N76 to the HT on your Android phone, and to avoid interference, switch to a different, unused frequency, for example, 438.100 MHz.
In the top-right corner of the HT APP, tap the three dots and then enter "Settings". Configure the following settings separately:

Settings-ID signaling- The very bottomBSS/APRS routing，TTL、Maximum forwarding countTwo set to 2
Settings-APRS Configuration：
- Log inEnter your own call sign password, for exampleBG4IJK-1
- Turn onIGate gatewayThe switch on the right, then turn it on.Radio to Internetthe switch
- Share location-IconTo make it easier to understand, find an icon for a cell tower./r

After adjusting, switch to another radio that can transmit APRS, setting the frequency to 438.1 MHz and the call sign.BG4IJK-7Once the icon of the person, and other devices have successfully located (placed by the window or outdoors), use it to send a beacon signal into the frequency. Then you can see that two have appeared on the APRS map.BG4IJKAdditionally, "Little Person" BG4IJK-7 reported through "Iron Tower" BG4IJK-1.

BH3PTS

BG4IJK Therefore, the ht software separates the paths "wide1-1" and "wide2-2" into options, but it doesn't allow for adding paths similar to those used by ARISS.

ping

BG4IJK Is it absolutely necessary to have a separate APRS-capable device in order to send APRS messages? My N76 is set up according to the instructions in the post, and I want to send messages over the network, but they are not appearing on aprs.tv. I've checked that my password and other settings are correct, so what could be wrong?

BI4MIG

BG4IJK
I don't understand it yet, but I'll take a look and try to figure it out in a few days.

zforce

Learned

BA7NNC-JOE

BH3PTS Sure, that's possible.

BH3PTS

BA7NNC-JOE Learned a lot, thank you.

BG5JRO

Thank you very much!

BG4IJK

BI4MIG I used AI to translate the above paragraph:

This passage is actually teaching people how to...How to use the Wino N76 as a "relay" (gateway) to receive and process radio location signals from nearby sources.（APRS）Upload to the internet map。
To make it easier for beginners to understand, I have translated it into a"Beginner-friendly tutorial"Version:

Simple Explanation: How to set up an APRS gateway using N76

Core Principle:
You need to build a bridge.

One end of the bridgeIt's a radio wave (your N76 walkie-talkie);

The other end of the bridgeIt's the internet (your Android phone);

Purpose: After N76 receives location signals from nearby friendly stations, these signals are transmitted via the mobile phone's network to be displayed on the APRS map.

Step 1: Preparation

HardwareYou will need a Winno N76 radio and an Android phone with the "HT" app (Winno official app) installed.

ConnectionTurn on your phone's Bluetooth and connect to the N76.

Frequency selection: Adjust the frequency of N76 to a specific value.Idle frequency with no one speaking(For example, using a frequency of 438.100) to prevent interference with other people's conversations and also to prevent others from interfering with your data transmission.

Step 2: Configure the app (road repair)

Open the "HT" app on your phone, and tap the "three dots" in the top right corner.> "Settings": This involves performing two tasks:

Configure forwarding rules (tell the machine how to forward):
Found ID signaling -> The very bottom BSS/APRS routing。

Take TTL And Maximum forwarding count Both of these should be changed to numbers. 2(Just fill it in, regardless of why).

Set gateway identity (tell the map who you are):
Found APRS Configuration。

Log in: Enter your call sign and APRS password (e.g., BG4IJK-1, suffix -1 Typically represents a fixed location or gateway.

Switch on/off: First, open it up. IGate gatewayThen, open it again. Radio to Internet(This step is crucial; it means allowing you to broadcast the received radio waves over the internet).

Select icon: I recommend choosing a "cell tower". /r Icons, so that others can easily identify you as a relay station on the map.

Step 3: Practical testing (inspection)

The settings I've made aren't working; I need to try this now to see if it works:

Get another walkie-talkie.(This radio should be able to transmit APRS, such as the handheld Yaesu UG-UV98 or other radios).

Also adjust the frequency of this test machine to. 438.100(Must be identical to N76).

Assign a call sign to the test machine (e.g., BG4IJK-7，-7 (Representing a handheld device), the icon features a "small person".

Take the test device to the window or outdoors (making sure you can receive GPS).Press the transmit button to send the location beacon.。

Step four: Witness a miracle

Open an APRS map website (such as aprs.fi):

If you seeTwo icons(One is your gateway, "Iron Tower," and the other is your test machine, "Little Person.")

And when you click on the "miniature" icon to view its information, you'll find that the path indicates it is:Uploaded via "Iron Tower"；
Congratulations! Your N76 APRS link has been successfully established!

Also, to add one more point about AI translation, when conducting outdoor testing, the phone should be used together with the N76.

BG0EQG

BG4IJK 👍

BI4MIG

BG4IJK
I understand. So, if I want to use the N76 as a gateway and send data directly to another gateway, which would function as a test device, then there's no need for this specific configuration.🤣I'm now wondering how to set up a "test machine." I'll search for information on that.

BD1DNK

BI4MIG Configure the transmitter to use channel 144.640, select APRS as the transmission format, and do not select BSS. Avoid entering a large number of maximum retransmission attempts to prevent multiple repeaters from continuously forwarding the signal. Once a gateway receives the signal, it will be uploaded to the internet.

闽ICP备2021006864号-7

闽公网安备35020602002794号互联网举报中心

用户协议隐私政策社区规范积分规则中继规则转载须知
更新日志联系我们常见问题友情链接运营报告赞助

浩奇科技（厦门）有限公司

是无线电，把我们联系在一起