我的宝锋 DM1701 刷新成功后，刷不进汉化的文件，我把本地的中继参数都写进去了，目前显示的全是英文和乱码，我该怎么刷进汉化的文件，显示的错误提示是：radid not connected. or not in DFU mode

需要进入dfu模式关机状态一起按最上面按钮➕ptt按钮状态开机指示灯会闪烁进入刷机模式写频不需要进刷机模式刷机必须进dfu模式

我就是按照说明操作的今天想着重新刷一次把原来错误的地方覆盖掉但是已经写不进任何固件了读写频率倒是正常的

2个模式驱动不同的的一个是串口一个是什么玩意 dfu?? 也要驱动是不是驱动掉了

After flashing the DM1701 with firmware, the Chinese localization files are not loading.

BG8JVA

After my BaoFeng DM1701 successfully flashed, I'm unable to flash the Chinese language file. I have entered all the local repeater parameters. Currently, it only displays English and gibberish. How can I flash the Chinese language file? The error message displayed is: "radid not connected" or "not in DFU mode".

BH3NZN

You need to enter DFU mode, with the device powered off and the top button and PTT button both pressed. The indicator light will flash, indicating that you have entered flashing mode. Note: writing does not require entering flashing mode. Flashing always requires entering DFU mode.

BG8JVA

I followed the instructions exactly. Today, I thought about re-flashing to correct the previous errors, but I can't flash any firmware anymore. However, the read/write frequency seems normal.

BI2QD

2 modes that drive different things: one is serial, and the other is...? dfu?? Also needs to be supported.

Did the driver get removed?

闽ICP备2021006864号-7

闽公网安备35020602002794号互联网举报中心

用户协议隐私政策社区规范积分规则中继规则转载须知
更新日志联系我们常见问题友情链接运营报告赞助

浩奇科技（厦门）有限公司

是无线电，把我们联系在一起