FT-710 remote

LoseHu

FT-710终于到了，喜欢得很，但是放在宿舍，想在工位上每天也玩，正好笔记本电脑A可以放在宿舍，在工位上有一台电脑B可以操作。
首先就是在宿舍电脑A安装rcforb服务端，同时使用花生壳、蒲公英这种端口映射软件配置好端口映射（免费额度够用），或者有服务器的可以用ssh端口转发，然后在工位电脑安装rcforb客户端，通过映射的公网ip就可以访问到赛博电台了，此时只能看到一个赛博电台界面，并非电台显示屏界面，但是可以听到和发送声音。
F-710同时具备一个DIV输出接口，可以在电脑A安装视频采集卡，然后通过远程软件例如todesk访问电脑A的桌面，同时把rcforb客户端也在电脑A打开，这时就能通过todesk同时看到FT710的显示器并且控制710了，还能听到和发送（未测试）声音。
使用rcforb操作电台终究没有直接操作电台显示屏方便（例如频谱快速跳转），好在710支持鼠标输入，只要整一个类似pikvm硬件，将电台的显示输出到kvm，同时kvm输出HID鼠标键盘，再将kvm连接到路由器。这时候就有两个方案：
1.在电脑A上连接到kvm，然后利用todesk直接远控电脑A就能完成集大成化操作；
2.配置路由器设置好端口映射/转发，通过外网映射/转发的ip 来观看电台显示屏，同时鼠标键盘控制，同时用rcforb客户端对电台主要控制。
目前用的是第二种方案，在电脑A上用花生壳映射了rcforb的两个端口到外网，同时用kvm+路由转发来实现鼠标键盘控制和显示输出
买了一个小米智能插座49r+div-hdmi连接线 5.9r，kvm+usb采集卡 91，小米路由器+网线40，一共200不到，200欠点
等过几天kvm到了试试效果

BG2EFX

Actually, if you're just looking to play FT8...
FLRIG + TODESK is sufficient...

BH7HQT

YAESU: My official remote control box is 1K2.
ICOM: I have the official software 600.
YAESU: I have a DVI
ICOM: I have official software.

BG7DKN

I have only used it remotely twice, directly using the Sunflower remote control.

During use, it was found that using this unbalanced antenna, which is a coaxial feed antenna, could cause the USB cable to break during transmission, while the radio would remain in an active state.

Later, remote operation was discontinued. Ham radio operators using unbalanced antennas should be aware of this.

LoseHu

BG7DKN I also use GP like this.

BG7DKN

LoseHu Is there a way to remotely shut down a radio that is in transmit mode? Otherwise, it's too dangerous.

BG2EFX

LoseHu After all, GP is just one arm. Let's put a foreign body obturator in Baron's throat.

dxs660

LoseHu GP is also an unbalanced antenna.

BG2EFX

BG7DKN Radio power supply: Install a smart switch on the 220V line.

LoseHu

BG7DKN Xiaomi smart plug, as mentioned before, for 49 RMB.

BI7KGD

Don't use Tox, try Parsec + ZeroTier instead.
Then buy a shielded USB cable with a magnetic connector.

LoseHu

BI7KGD Let's skip ZeroTier then; it's not worth it if your network connection is already poor.

LoseHu

BI7KGD Can simply buying a shielded USB cable with a magnetic connector solve the problem?

BI1RRE

ICOM 705 public IP + internal port mapping, used in conjunction with FT8CN for direct IP port connection. When using FT8 or the official remote control software, I found it less convenient than using a smartphone.
Yaesu FTDX-10 directly connected to a JTDX GridTracker/Rustdesk, allowing for remote connection from mobile devices or PCs in the office for FT8 operation.
Regarding the issue with the antenna loop, in environments similar to those used with the GP antenna, PC, and power supply, the ICOM 705's antenna loop showed some effect, but it was also unstable. However, the Yaesu radio did not experience any port dropouts. Therefore, I abandoned the USB connection method for the 705 and switched to Wi-Fi.

Liridice

If I can only remotely turn off a device with a smart switch, is there a way to also remotely turn it on? Should I buy a graffiti-controlled finger robot?

Liridice

Syryia Indeed, the FT-710 also automatically starts up after a power outage.

闽ICP备2021006864号-7

闽公网安备35020602002794号互联网举报中心

用户协议隐私政策社区规范积分规则中继规则转载须知
更新日志联系我们常见问题友情链接运营报告赞助

浩奇科技（厦门）有限公司

是无线电，把我们联系在一起