The initial purpose of creating this antenna base was because I had recently purchased an SG7900 antenna and a smoker head, and I occasionally needed to set it up in the outdoors. It was important that it could be easily disassembled and reassembled.
After searching online, I couldn't find anything suitable, so I decided to make one myself.
The samples produced are 5 in total, and I have already sold 4 of them. I am keeping the remaining one. It is made of 304 stainless steel with a thickness of 3mm, and weighs approximately 0.5 kg.
The center has 8 screw holes for attaching the tripod quick-release plate base, and the quick-release plate supports both 3/8" and 1/4" tripods.
The surrounding area has 8 antenna mounting bases, supporting both large and small flanges, as well as panel-through hole fixing. It can accommodate a maximum of 8 antenna bases simultaneously.
The outer 16 holes are used for fixing or as a ground wire. When not using the base, you can also use the hanging rings on both sides to pull them up and use them as a connection panel for aerial feed.
Project address: https://github.com/PretendTesting/mechanical
If you need to use M's antenna as a base, you will need to increase the hole size and modify it yourself.
闽ICP备2021006864号-7
闽公网安备35020602002794号