有没有老师做NXO-100的1：1巴伦，我想请教一下绕线😭

M哥B站有视频，我在B站也做了1：1巴伦的视频，可以参考一下

@"BG8AMG"#p20641 我也看了m哥的视频，照着做但是我的参数不理想😭

从我的经验来看，参数不好，有可能是线头的处理没做好绕线一定要紧，磁环出线到馈线座一定要短，并且不能有直角。可以用天分看着，用手一点点调整里面引线的位置弯曲度之类的，就能慢慢调到想要的参数了

@"BI1LWR"#p20719 谢谢老师，下午我把天线架起来测了一下，驻波1.2左右，阻抗在51欧姆，但是没收到信号

NXO-100 1:1 Scale Model

BH8UXK

Does anyone have a 1:1 wiring diagram for the NXO-100? I would like to ask about the wiring.😭

BG8AMG

My friend M has a video on Bilibili, and I also made a 1:1 Barren video on Bilibili. You can refer to it.

BH8UXK

BG8AMG I also watched m's video and tried to follow his instructions, but my results weren't ideal.😭

BI1LWR

Based on my experience, if the parameters are not correct, it could be due to improper handling of the filament end.

The winding must be tight, and the output from the magnetic ring to the feed-through connector should be as short as possible, and it should not have any right angles.

You can adjust the parameters gradually by visually inspecting and manually adjusting things like the position and curvature of the internal wires.

BH8UXK

BI1LWR Thank you, teacher. This afternoon, I set up the antenna and measured it; the standing wave ratio was around 1.2, and the impedance was 51 ohms, but I didn't receive any signal.

闽ICP备2021006864号-7

闽公网安备35020602002794号互联网举报中心

用户协议隐私政策社区规范积分规则中继规则转载须知
更新日志联系我们常见问题友情链接运营报告赞助

浩奇科技（厦门）有限公司

是无线电，把我们联系在一起